Welcome to Decware
The DECWARE model T6
"The T6 are small bookshelf speakers featuring an exotic 6.5" crossoverless driver with an equally exotic cabinet in high gloss Rosewood."
What sets thE T6 SPEAKERS APART?
The midrange is present, silky and smooth.
The bass is as fast as the midrange but with nice weight and no boom!
Imaging with feedback free tube gear is memorable.
The soundstage depth is intoxicating in good rooms.
High quality non-magnetic binding posts -- you'll want good wire with these.
High mass curved enclosure.
High gloss Rosewood piano finish is standard.
Will work with as little as 2.3 Decware watts.
Sounds great with or without a subwoofer.
With the success of our Tube Tots, we decided to offer an additional model called the T6. It's slightly larger than our Tube Tots but not by much. What it brings to the table is a bit more efficiency and a single 6.5 inch neodymium driver acting as a point-source in another very exotic cabinet.
This is the kind of speaker that you would sneak into the back room with after selling high dollar flagship speakers all day.
The T6 come with a 30 day trial and a pair can typically ship within 8 weeks.
These are another personal favorite of mine. They are good enough to stand mount and retire with. They easily show of the full potential of even the most expensive gear.
Steve Deckert / DECWARE
Model DECWARE T6
The following gated measurements were taken at 12 inches from the speaker while turned up to a healthy SPL.
Dark Green = 0 degrees, Light Green = 15 degrees, Blue = 30 degrees.
Waterfall plot at high SPL
RMS Average Response
TTL harmonic distortion (white) vs. response (dark orange) at 110dB SPL
Frequency Response - 55Hz~17kHz
Impedance - 8 ohms
Power - 50 watts
Sensitivity - 94dB
Size - 9" wide x 14.5" high x 11.8" deep
Net Weight - 39.8 lbs.
Packaged Weight - 48.5 lbs.
DECWARE TUBE TOTS JAZZ DEMO 1
DECWARE TUBE TOTS NOVEMBER DEMO 1
DECWARE TUBE TOTS -- INFECTED MUSHROOM DEMO
The DECWARE model T6
NOTE: Many have asked what stand we recommend, and obviously an expensive well engineered stand would be our first choice. But if you need something to get you by we have found a glass stand on Amazon for around $60 that we we have tested and found to have a synergy with these particular T6 speakers as well as our Tube Tots. In both cases we use rubber pads or o-rings in place of the threaded spikes. You can find these stands on Amazon.